How to use “Hoop Connectors”

The "hoop connectors" were designed by one of our customers and Farthingales had them made. Unfortunately they are no longer available. They are constructed of rust proof steel that increases their functionality but decreases the aesthetic appeal. These are not "universal"; they were engineered to fit specific steel. Two sizes are available. More information can be found in the catalogue under "hoop steel".

NOTE: when making your hoop steel casing measure the width of the connector in order to be sure it will slide through the casing also.

1. Slide the hoop connector onto one end of a length of steel, allowing for the extra length gained by adding the connector measure your steel starting at the exterior tip of the connector and then cut the steel at the desired length.

2. Leave the connector on the steel and use it as the leading end when sliding it into the casing you have made. The connector has rounded ends and will not catch on the casing. Slide the steel into the casing until the connector comes out the other end.
   
   
3. Slide the connector onto the "tail" end of the steel that should be sticking out from the casing where you started and push far enough in to make a firm connection.

Note: You may need to loosen the connector before sliding in the steel, if so use a flat screw driver to pry up the edges, slightly. If needed, use pliers to re tighten.

Back view of connector when in place:

ORDER FORM | PRICE LIST | PRODUCT SEARCH | SHOPPING CART | POLICIES
CATALOG INDEX | PATTERNS | BONES/STAYS | METRIC CONVERTER | KEY TO UNIT LETTER CODES
LINKS & RESOURCES | LECTURES & CLASSES | PERIOD COSTUME
ONLINE CLASSES | CORSET BOOK | PHOTO ALBUM | TIPS & TRICKS | MAGAZINES | BOOK STORE
FARTHINGALES BIOGRAPHY | CONTACT US | HOME | HOW TO USE THIS SITE & SITEMAP